Lantronix XN manual Tunnel Connect Mode Settings, Tunnel Connect Mode Description Settings

7: Line and Tunnel Settings

For Connect Mode using UDP, the PremierWave XCPremierWave XNPremierWave ENEDS- MD4/8/16 accepts packets from any device on the network. It will send packets to the last device that sent it packets.

Note: The Port in Connect Mode is not the same port configured in Accept Mode.

The TCP keepalive time is the time in which probes are periodically sent to the other end of the connection. This ensures the other side is still connected.

	Table 7-6 Tunnel Connect Mode Settings
Tunnel Connect Mode	Description
Settings
Mode	Set the method to be used to attempt a connection to a remote host or device.
	Choices are:
	 Disable = an outgoing connection is never attempted. (default)
	 Always = a connection is attempted until one is made. If the connection gets
	disconnected, the PremierWave retries until it makes a connection.
	 Any Character = a connection is attempted when any character is read on
	the serial line.
	 Start Character = a connection is attempted when the start character for the
	selected tunnel is read on the serial line.
	 Modem Control Asserted = a connection is attempted as long as the
	Modem Control pin (DSR) is asserted, until a connection is made.
	 Modem Emulation = a connection is attempted when triggered by modem
	emulation AT commands.
Local Port	Enter an alternative Local Port. The Local Port is set to <Random> by default
	but can be overridden. Blank the field to restore the default.
Host 1	Click on the displayed information to expand it for editing. If <None> is
	displayed, clicking it will allow you to configure a new host. At least one Host is
	required to enable Connect Mode as this information is necessary to connect to
	that host.
Reconnect Timer	Set the value of the reconnect timeout (in milliseconds) for outgoing connections
	established by the device. Valid range is 1 to 65535 milliseconds. Default is
	15000.
Flush Serial Data	Set whether the serial Line data buffer is flushed upon a new network
	connection. Choices are:
	 Enabled = serial data buffer is flushed on network connection
	 Disabled = serial data buffer is not flushed on network connection (default)
Block Serial	Set whether Block Serial is enabled for debugging purposes. Choices are:
	 Enabled = If Enabled, incoming characters from the Serial Line will not be
	forwarded to the network. Instead, they will be buffered and will eventually
	flow off the Serial Line if hardware or software flow control is configured.
	 Disabled = this is the default setting; incoming characters from the Serial Line
	are sent on into the network. Any buffered characters are sent first.
Block Network	Set whether Block Network is enabled for debugging purposes. Choices are:
	 Enabled = If Enabled, incoming characters from the network will not be
	forwarded to the Serial Line. Instead, they will be buffered and will eventually
	flow off the network side.
	 Disabled = this is the default setting; incoming characters from the network
	are sent on into the Serial Line. Any buffered characters are sent first.

PremierWave XN User Guide 53