6:Network Settings

The Network Settings show the status of the Ethernet or WLAN interface/link and let you configure the settings on the device. Interface settings are related to the configuration of the IP and related protocols. Link settings are related to the physical link connection, which carries the IP traffic.

The PremierWave XN contains two network interfaces. Only one interface may be active at a time; however, if bridging is enabled, both interfaces will be activated and controlled by the bridging subsystem.The Ethernet interface is also called interface 1 or eth0, and the WLAN interface is called interface 2 or wlan0.

Notes:

Some settings require a reboot to take effect. These settings are noted below.

Wait a minimum of 10-20 seconds after rebooting the unit before attempting to make any subsequent connections.

The blue text in the XML command strings of this chapter are to be replaced with a user-specified name.

Network Interface Settings

Table 6-1shows the network interface settings that can be configured.

These settings apply to both the Ethernet (eth0) and WLAN (wlan0) interfaces, but are configured independently for each interface.

 

Table 6-1 Network Interface Settings

 

 

Network Interface

Description

Settings

 

State

Enables or disables the interface.

 

 

BOOTP Client

Select to turn On or Off. At boot up, after the physical link is up, the

 

PremierWave will attempt to obtain IP settings from a BOOTP server.

 

Note: Overrides the configured IP address/mask, gateway, hostname, and

 

domain. When DHCP is Enabled, the system automatically uses DHCP,

 

regardless of whether BOOTP is Enabled. Changing this value requires you to

 

reboot the device.

 

 

DHCP Client

Select to turn On or Off. At boot up, after the physical link is up, the

 

PremierWave will attempt to obtain IP settings from a DHCP server and will

 

periodically renew these settings with the server.

 

Note: Overrides BOOTP, the configured IP address/mask, gateway,

 

hostname, and domain. Changing this value requires you to reboot the device.

 

Note: Within WebManager, click Renew to renew the DHCP lease.

 

 

PremierWave XN User Guide

32

Page 32
Image 32
Lantronix XN manual Network Settings, Network Interface Settings, Network Interface Description Settings