Lexmark 3455 manual Using the Simm for Ipds with the Adapter for SCS

8 Using the SIMM for IPDS with the Adapter for SCS

8.1 Using the Coax/Twinax Adapter for SCS

This section describes how to set up the Adapter for SCS to make it possible to print IPDS data to either a direct coaxially attached printer or a direct twinaxially attached printer. Please refer to Appendix A for a list of compatible hardware attachments and supported host software.

Adapter for SCS Code Levels Required

H01-9072 (or greater) for coax

H02-8491 (or greater) for twinax

To see the Adapter for SCS code level, you need to use the printer's operator panel. The last four digits (in "8491") are the ones you want to be greater than or equal to.

To print a Firmware Summary, follow these steps

1.When Ready or Power Saver displays in the operator panel, press Menu> to move to NETWORK MENU. Press Select. You will then see NETWORK OPTION 1, NETWORK OPTION 2 or NETWORK OPTION 3 display. Pick the number corresponding to the option slot the adapter is installed in. Press Select.

2.Press Menu> until you see SCS MENU 1, SCS MENU 2 or SCS MENU 3 display.

3.Press Select. Press Menu> until you see TESTS OPTIONS.

4.Press Select. Firmware Summary displays. Press Select.

5.Press Menu> until you see Print. Press Select. A short report listing the revision numbers will print.

121