Lexmark 3455 manual Nomax

IPDS Timeout = 15 seconds to 10 minutes (when using a MarkNet internal print server only)

If you selected the IPDS Timeout value of Host Controlled to allow the host to directly control ending (disconnecting) a LAN session, go to IPDS Timeout = Host Controlled on page 135.

If you selected an IPDS Timeout value of 15 seconds to 10 minutes to allow the printer IPDS emulation to determine when an IPDS LAN session times out, follow the steps below to correct the problem.

1.Adjust the MarkNet internal print server end-of-job timeout value to 0 (disabled). See 7 Using the SIMM for IPDS with a MarkNet Internal or External Print Server on page 83 for additional information.

2.Change the host port setting to 9600. Refer to IPDS Timeout on page 40 for further information on the selection of ports.

3.Correct the appropriate host timer/timeout value as shown below.

Note: The host timer/timeout values below should not be used with a host port value of 9100 or 9102.

PSF/400 with OS/400 V3R1 or V3R6
WRKAFP2: Inactivity Timer (INACTTMR)	*NOMAX

PSF/400 with OS/400 V3R2, V3R7, V4R1, V4R2, V4R3, or V4R4

CRTPSFCFG: Release Timer (RLSTMR)	*NOMAX
PSF/MVS
PSF Startup Proc: Disconnect Interval (DISCINTV)	0
PSF/2
TCP/IP Settings: Connect Timeout	0
Tuning Option: Job Interval Shutdown Timer	9999
PSF/AIX
SMIT Printer Def: Connect Timeout	0

136