Lexmark 3455 manual Using the Coax Interface with Ipds Ipds Enabled Setting

8.2 Using the Coax Interface with IPDS

Note: When coax attached, the Adapter for SCS will, by default, use the IPDS emulation if a SIMM for IPDS is installed. If you install a new Adapter for SCS in an Optra printer with a SIMM for IPDS (and vice versa), you do not need to configure the Adapter for SCS to use the IPDS emulation.

8.3 IPDS Enabled Setting

This is a setting on the Adapter for SCS, which only appears when the SIMM for IPDS is detected in the printer. The default is “Yes” (IPDS is enabled).

From the printer operator panel, do the following:

1.Press Menu> until NETWORK MENU displays. Press Select.

2.Press Menu> until NETWORK OPTION 1 displays. Press Select. (This example assume the Adapter for SCS is installed in option connector 1.)

3.Press Menu> until you see SCS MENU 1. Press Select.

4.Press Menu> until you see IPDS OPTION. Press Select.

Here you find the setting:
IPDS Enabled	Yes*
	No

To pass IPDS or SCS data to the SIMM for IPDS, select “Yes”.

To pass only SCS data to the SIMM for IPDS, select “No”.

Note: Changes to this setting become active only after the printer is powered OFF and then powered ON.

123