Lexmark 3455 manual Recommended memory on Problem

2.Problem:

The message 36 Resolution Reduced displays and the printer stops.

Solution:

The printer memory is full and the page cannot be printed at the selected IPDS Resolution. Press Go and the page is printed at a lower resolution. If this is a constant problem and you want to print at the higher resolution, you need to add more memory to the printer.

This message is an informational message on some Optra models. The printer will display the message and continue printing the job without operator intervention. If this message continues to appear when printing jobs, add more memory to the printer.

For information on the minimum recommended installed memory, see appendix

C.Recommended memory on page 171.

3.Problem:

Sometimes an IPDS memory exception is reported to the host.

Solution:

The memory may be used by PCL or PostScript. It cannot be used by IPDS. You need to do one or more of the following:

A.Set Resource Save to “Off” to allow permanent downloaded resources from PostScript and PCL jobs to be deleted. Resource Save is found under SETUP MENU on the printer operator panel. Try reprinting the job after powering the printer OFF and ON.

B.There may be insufficient printer memory to print the IPDS job with the selected IPDS resolution. Select a lower IPDS Resolution and try reprinting the job. If using the Adapter for SCS, you must power the printer OFF and ON for this change to take effect.

137