Lexmark 3455 manual Configuring a MarkNet XLe External Print Server, Printing a MarkNet XLe Setup

7.4Configuring a MarkNet XLe External Print Server

To enable IPDS printing with the MarkNet XLe several settings must be changed. Changes to MarkNet XLe settings can only be made using the appropriate network printer utilities. For more information on how to change these settings, refer to your Lexmark network adapter manual, which came with your print server.

	Network Adapter User's Guide or
N	Network Adapter Hardware Setup or
	MarkNet XLe Setup and Service Guide

7.4.1 Printing a MarkNet XLe Setup Page

Microcode Level

MarkNet XLe 04.130.01 (or greater)

To see the code level, you need to print the setup page. Under the section Network Card, look for Firmware Revision. The middle number (in this case “130”) is the one you want to be greater than or equal to.

To print the MarkNet XLe setup page, do the following:

1.Remove the adapter’s switch cover.

2.Press the Test button until the Test light comes on. The XLe setup page will print on the attached printer.

3.Replace the adapter’s switch cover.

For more information, see Lexmark’s Network Printer Utility Guide.

If you need to update your MarkNet XLe code level, contact the Lexmark Technical Support Center. MarkNet XLe firmware updates are also available from the Lexmark web site at http://www.lexmark.com.

89