Lexmark MX611DE, 35S6701, 35S3332, 34TT016, MX611DHE manual Understanding the printer menus 169

Understanding the printer menus		169
	Use	To
	Web Page Refresh Rate	Specify the number of seconds between Embedded Web Server
	30–300	refreshes.
		Note: 120 is the factory default setting.
	Contact Name	Specify a contact name for the printer.
		Note: The contact name will be stored on the Embedded Web
		Server.
	Location	Specify the location of the printer.
		Note: The location will be stored on the Embedded Web Server.
	Alarms	Set an alarm to sound when the printer requires user intervention.
	Alarm Control	When activated, Alarm Control lets you set the number of times
	Cartridge Alarm	that the alarm sounds, while Cartridge Alarm lets you stop printing
		when a cartridge‑low condition occurs.
	Staple Alarm
		For each alarm type, select from the following options:
		Off
		Single
		Continuous
		Notes:
		• Single is the factory default setting for Alarm Control. This
		sounds three quick beeps.
		• Off is the factory default setting for Cartridge Alarm and
		Staple Alarm. This means no alarm will sound.
		• Continuous repeats three beeps every 10 seconds.
	Timeouts	Specify the number of minutes of inactivity before the printer
	Standby Mode	enters a lower power state.
	Disabled	Note: 15 is the factory default setting.
	1–240
	Timeouts	Set the amount of time in minutes the printer waits after a job is
	Sleep Mode	printed before it goes into a reduced power state.
	Disabled	Notes:
	1–180	• 30 is the factory default setting.
		• Lower settings conserve more energy, but may require
		longer warm‑up times.
		• Select the lowest setting if the printer shares an electrical
		circuit with room lighting or you notice lights flickering in the
		room.
		• Select a high setting if the printer is in constant use. Under
		most circumstances, this keeps the printer ready to print
		with minimum warm‑up time.