Lexmark 35S3332 Smtp server not set up. Contact system administrator, Standard USB port disabled

Troubleshooting 266

SMTP server not set up. Contact system administrator.

From the printer control panel, touch Continue to clear the message.

Note: If the message appears again, then contact your system support person.

Some held jobs were not restored

From the printer control panel, touch Continue to delete the indicated job.

Note: Held jobs that are not restored remain in the printer hard disk and are inaccessible.

Standard network software error [54]

Try one or more of the following:

•From the printer control panel, touch Continue to continue printing.

•Turn off the printer, and then turn it back on.

•Update the network firmware in the printer or print server. For more information, visit the Lexmark support Web site at http://support.lexmark.com or contact customer support, and then report the message.

Standard USB port disabled [56]

Try one or more of the following:

•From the printer control panel, touch Continue to clear the message.

•Enable the USB port. From the printer control panel, navigate to: Network/Ports > USB Buffer > Auto

Note: The printer discards any data received through the USB port.

Supply needed to complete job

Do either of the following:

•Install the missing supply to complete the job.

•Cancel the current job.

Too many flash options installed [58]

1Turn off the printer.

2Unplug the power cord from the electrical outlet.

3Remove the extra flash memory.

4Connect the power cord to a properly grounded electrical outlet.

5Turn the printer back on.