Lexmark 34TT016, 35S6701 Too many trays attached, Unformatted flash detected, Unsupported disk

Troubleshooting 267

Too many trays attached [58]

1Turn off the printer.

2Unplug the power cord from the electrical outlet.

3Remove the extra trays.

4Connect the power cord to a properly grounded electrical outlet.

5Turn the printer back on.

Unformatted flash detected [53]

Try one or more of the following:

•From the printer control panel, touch Continue to stop the defragmentation and continue printing.

•Format the flash memory.

Note: If the error message remains, then the flash memory may be defective and needs to be replaced.

Unsupported disk

Remove the unsupported printer hard disk, and then insert a supported one.

Unsupported option in slot [x] [55]

1Turn off the printer.

2Unplug the power cord from the electrical outlet.

3Remove the unsupported option card from the printer controller board, and then replace it with a supported card.

4Connect the power cord to a properly grounded electrical outlet.

5Turn the printer back on.

USB port [x] disabled [56]

From the printer control panel, touch Continue to clear the message.

Notes:

•The printer discards any data received through the USB port.

•Make sure the USB Buffer menu is not set to Disabled.

Weblink server not set up. Contact system administrator.

From the printer control panel, touch Continue to clear the message.

Note: If the message appears again, then contact your system support person.