Lexmark 036, 436, 236 manual Load staples G11, G12, Maintenance kit very low 80.xy, Memory full

Troubleshooting 278

Load staples [G11, G12]

Try one or more of the following:

•Replace or insert the staple cartridge into the finisher.

For instructions on replacing or inserting the staple cartridge into the finisher, touch More information on the control panel.

•From the control panel, touch Continue to clear the message and continue printing.

•Cancel the print job.

[x] maintenance kit very low [80.xy]

You may need to replace the maintenance kit very soon. For more information, go to the Lexmark support Web site at http://support.lexmark.com or contact customer support, and then report the message.

If necessary, touch Continue to clear the message and continue printing.

Memory full [38]

Try one or more of the following:

•From the control panel, touch Cancel job to clear the message.

•Touch Reset active bin to reset the active bin for a linked set of bins.

•Install additional printer memory.

Memory full, cannot print faxes

From the printer control panel, touch Continue to clear the message without printing. Held faxes attempt to print after the printer is restarted.

Memory full, cannot send faxes

1From the printer control panel, touch Continue to clear the message and cancel the fax job.

2Try one or more of the following:

•Reduce the fax resolution, and then resend the fax job.

•Reduce the number of pages in the fax, and then resend the fax job.

No analog phone line connected to modem, fax is disabled.

Connect the printer to an analog phone line.

Network [x] software error [54]

Try one or more of the following:

•From the printer control panel, touch Continue to continue printing.

•Turn off the printer, wait for about 10 seconds, and then turn the printer back on.