Lexmark MX711DE manual Too many flash options installed, Too many trays attached, Unsupported disk

Troubleshooting 290

3Remove the extra printer hard disks.

4Connect the power cord to a properly grounded electrical outlet.

5Turn the printer back on.

Too many flash options installed [58]

1Turn off the printer.

2Unplug the power cord from the electrical outlet.

3Remove the extra flash memory.

4Connect the power cord to a properly grounded electrical outlet.

5Turn the printer back on.

Too many trays attached [58]

1Turn off the printer.

2Unplug the power cord from the electrical outlet.

3Remove the extra trays.

4Connect the power cord to a properly grounded electrical outlet.

5Turn the printer back on.

Tray [x] paper size unsupported

Replace with a supported paper size.

Unformatted flash detected [53]

Try one or more of the following:

•From the printer control panel, touch Continue to stop the defragmentation and continue printing.

•Format the flash memory.

Note: If the error message remains, then the flash memory may be defective and needs to be replaced.

Unsupported camera mode, unplug camera and change mode

The camera mode does not support PictBridge.

Unplug the camera, change the mode and plug the camera back into the printer.

Unsupported disk

Remove the unsupported printer hard disk, and then insert a supported one.