Linear DUAL 824 manual Programming Different Sensor Types

PROGRAMMING DIFFERENT SENSOR TYPES

✦Follow the instructions on the previous page to select a sensor number to program the sensor into.

✎NOTE: A sensor can be programmed into more than one location. Be sure to choose an UNUSED sensor number. If a sensor gets entered into more than one location, delete the duplicates using the remove sensor function.

✦To add DXS-10 wireless keypads, press and hold the keypad's key until programmed into the Control Panel.

✦For DXS-31 and DXS-32 door/window sensors, move the magnet away from the side of the sensor.

✎IMPORTANT NOTE: The DXS-31 & DXS-32 door/ window sensors are pre-set at the factory for delayed burglary response. If the sensor is going to be used on a non-entry portal (window, sliding glass door, etc.) a jumper can be changed in the sensor to select instant response. The jumper should be changed before programming the sensor so the Control Panel will assign the sensor to the proper sensor function. See the “Basic Sensor Installation” section of this manual or the sensor’s instructions for details on changing the jumper.

✦For DXS-81, DXS-91, DXS-54, DXS-73, & accessory sensors, simply send a test transmission (refer to the sensor's instructions for details on sending a test transmission).

DXS-10

DXS-32

DXS-81

16