Linear DUAL 824 manual Programming Different Sensor Types Cont

PROGRAMMING DIFFERENT SENSOR TYPES (CONT.)

✦For DXT-61, DXT-21, DXS-21, DXT-41, & DXS-62A single-button remotes, simply press the unit's button.

✎NOTE: After the Control Panel recognizes the transmitter, single-button remotes must be re-programmed as “panic buttons” or home automation controllers. Refer to Page 28 in the “Customizing the System” section of this manual.

✦For DXT-23, DXS-23, & DXT-42 multi-button remotes: Learn the transmitter by pressing the left button. The remote will arm the Control Panel with the left button and disarm with the right button. Labels are provided with the DXT-42 for identifying the buttons.

✎NOTE: After the Control Panel “learns” the transmitter, multi-button remotes can easily be re-programmed to have the left button arm/disarm the Control Panel and the right button activate/ deactivate the Home Automation output. Refer to the “Advanced Programming” section of this manual.

For All Models:

✴A single “Bing” tone will sound and the sensor status indicator will stay lit when the sensor is programmed into the Control Panel.

✴A “Buzz” tone will sound if there is already another sensor programmed to that sensor number.

✦Exit Setup Mode by pressing the key then press OFF for three seconds. Reminder: The system will automatically exit the Setup Mode and return to Off Mode after three minutes of keypad inactivity.

✎NOTE: To remove sensors from the Control Panel's memory, see Page 26 in the “Customizing the System” section of this manual.

DXT-21

SEND SIGNAL WITH LEFT BUTTON

DXT-42

LEFT = ARM/DISARM

RIGHT = DISARM

BOTH = EMERGENCY

17