Linear DUAL 824 manual Customizing the System, Adding Sensors to the System, Press Test

12.CUSTOMIZING THE SYSTEM

✦Adding additional sensors will increase the protection provided by the system.

✦All ground-level perimeter openings and accessible upper-story openings need protection.

✦Motion detectors can protect interior areas and areas where valuables are kept.

ADDING SENSORS TO THE SYSTEM

1.Always start with the system in Test Mode (enter a user code and press TEST).

2.Enter the master user code then press TEST.

✴A “Gong” and fi ve “Beeps” will sound.

✴The sensor status indicators will light for each sensor programmed into the Control Panel.

3.Enter an unused sensor number from 01-24 (you must enter two digits, example: 5 = 05).

✎NOTE: A sensor can be programmed into more than one location. Be sure to choose an UNUSED sensor number. If a sensor gets entered into more than one location, delete the duplicates using the remove sensor function.

✴The sensor status indicator light will fl ash for the sensor number selected.

4.Activate the sensor. (To add a wireless keypad, press the keypad's key.)

✴A “Bing” tone will sound when the sensor is programmed into the Control Panel and the sensor status indicator will stay lit.

✴A “Buzz” tone will sound if there is already another sensor programmed to that sensor number.

5.Enter another sensor number, or exit Setup Mode by pressing thekey then press OFF for three seconds.

REMOVING SENSORS FROM THE SYSTEM

✦If a previously programmed sensor isn't going to be used with the system anymore, or it's a duplicate that has been entered into more than one sensor location, it should be removed from the Control Panel's memory.

1.Start with the system in Test Mode.

2.Enter the master user code then press TEST.

✴A “Gong” and fi ve “Beeps” will sound.

✴The sensor status indicators will light for each sensor programmed into the Control Panel.

3.Enter the sensor number (from 01-24) that you want to remove (you must enter two digits, example: 5 = 05).

✴The sensor status indicator light will fl ash for the sensor number selected.

4.Press TEST.

✴A “Bing” tone will sound when the sensor has been removed and the sensor status indicator will turn off.

5.Enter another sensor number, or exit Setup Mode by pressing thekey then press OFF for three seconds.

START IN TEST

MASTER

USER

CODE

1 GONG & 5 BEEPS (SETUP MODE)

NEW SENSOR

NUMBER

SENSOR

INDICATOR

FLASHES

ACTIVATE

SENSOR

1 BING AND SENSOR INDICATOR LIGHTS

REPEAT OR EXIT

START IN TEST

MASTER

USER

CODE

1 GONG & 5 BEEPS (SETUP MODE)

NUMBER OF

SENSOR TO

REMOVE

SENSOR

INDICATOR

FLASHES

REMOVES

SENSOR

1 BING & SENSOR INDICATOR

DARK REPEAT OR EXIT

26