DXS-31 & DXS-32 DOOR/WINDOW SENSORS
✦ The |
to monitor doors, windows, cabinets, crawl space |
doors, gates, freezer doors, and many other |
moving objects that could be used for intrusion or |
need to be monitored. |
✦ A |
when its magnet (mounted on the moving part |
EXAMPLE INSTALLATIONS (WITH DXS-31 SHOWN)
LEFT OPENING DOOR
SLIDING WINDOW
TRANSMITTER
MOUNTED ON
DOOR JAMB 
MAGNET MOUNTED
ON WINDOW FRAME
(NOTE: SMALL END OF TRANSMITTER UP)
MAGNET MOUNTED
ON DOOR
TRANSMITTER
MOUNTED ON
WINDOW SILL
or the door or window) moves away from the |
sensor. |
✦ The |
normally closed switches for remote triggering. |
✦ The |
glass break detector. |
SET SENSOR JUMPER
✦A jumper inside the door/window sensor selects instant or delayed response.
1A. If the sensor is going to be used on the primary entry/exit door make sure that the jumper is in the DELAY position.
1B. If the sensor is going to be used on a window or a door that is not going to be used to enter and exit the premises, set the jumper to the INSTANT position.
RIGHT OPENING DOOR
TRANSMITTER
MOUNTED ON
DOOR JAMB
(NOTE: SMALL END
OF TRANSMITTER DOWN)
MAGNET MOUNTED
ON DOOR
INSTANT/DELAY | ANTENNA | |
OPTION JUMPER |
| |
INPUT | MAGNET | |
ALIGNMENT | ||
SELECT | MARK | |
JUMPER |
| |
TRANSMIT |
| |
INDICATOR |
| |
TEST | EXTERNAL | |
SWITCH | ||
INPUT | ||
| ||
| TERMINALS |
DOUBLE-HUNG
WINDOW
TRANSMITTER
MOUNTED ON
WINDOW FRAME
MAGNET
MOUNTED
ON WINDOW
SASH STILE
TWO TYPE 2032
BATTERIES
BATTERY
CLAMP
SCREW
BATTERY CLAMP
CHOOSE MOUNTING METHOD
2A. Apply
2B. Screws are also provided to mount sensors and magnets. Screws are preferred over the double- stick tape in permanent installations.
✎UL NOTE:
ATTACH SENSORS AND MAGNETS
✦Allow a maximum of 1/2" between magnet and sensor when door/window is closed.
✦The magnet height is adjustable and an optional magnet spacer is provided for uneven surfaces.
3A. On doors, mount sensor to door frame and magnet to door.
3B. On windows, mount sensor to window frame and magnet to window.
✎NOTE: Magnet must line up with mark on sensor case both horizontally & vertically.
4.Snap sensor onto mounting plate.
TEST SENSORS
INSTANT/DELAY
OPTION JUMPERSELECTS INSTANT
SELECTS
DELAY
ATTACH MOUNTING PLATES
USING THE SCREWS OR
NOTE: ATTACHING THE TRANSMITTER WITH
✴In Chime Mode, the hardwired keypad(s) should “ding- dong” when the sensor sends a signal.
5.Open door or window.
✴Verify that light on the sensor (if there is one) glows momentarily when door/window is opened.
✴Status indicator on the hardwired keypad(s) should remain lit for each door/window sensor that is left open.
OPEN DOOR, TRANSMIT INDICATOR SHOULD LIGHT
ACTIVATE TRANSMITTER BY OPENING DOOR OR WINDOW
REPLACE TRANSMITTER COVER WHEN FINISHED
NOTE: THE TRANSMIT INDICATOR WILL ONLY LIGHT DURING TRANSMISSIONS WHEN THE CASE IS OPEN (EXCEPT WHEN PUSHING THE CASE FOR TESTING)
19
