Linear DUAL 824 manual Automation Output While Armed, Automation Output During EXIT/ENTRY Delays

AUTOMATION OUTPUT WHILE ARMED
✦ The factory setting causes the Control Panel's	PROGRAMMING STEP #73
Automation Output to activate when pressing the
key, or when it's triggered with a two-button
remote control.	ENTERS STEP NUMBER
STEP #73 The Control Panel can be programmed to	0 FOR STANDARD TRIGGER
activate the Automation Output when the system
	1 FOR OUTPUT WHEN ARMED
is armed as well as when normally triggered	STORES VALUE - 1 BING
using this step.
AUTOMATION OUTPUT DURING EXIT/ENTRY DELAYS
✦ The factory setting causes the Control Panel's	PROGRAMMING STEP #74
Automation Output to activate when pressing the
key, or when it's triggered with a two-button
remote control.	ENTERS STEP NUMBER
STEP #74 The Control Panel can be programmed to	0 FOR STANDARD TRIGGER
activate the Automation Output during the exit	1 FOR OUTPUT DURING
and Entry Delays as well as when normally	EXIT/ENTRY DELAYS
	STORES VALUE - 1 BING
triggered using this step.
AUTOMATION OUTPUT POLARITY
✦ The factory setting causes the Control Panel's	PROGRAMMING STEP #75
Automation Output to provide a current limited
voltage source when activated.
STEP #75 The Control Panel can be programmed so the	ENTERS STEP NUMBER
Automation Output provides a current limited	0 FOR VOLTAGE WHEN OFF
voltage source when deactivated using this step.
	1 FOR VOLTAGE WHEN ON
	STORES VALUE - 1 BING

REMOTE ACCESS PASSWORD

✦This password is used to gain access to the Control Panel when using the RA-2400 remote access software. The password must be 6-digits long.

STEP #87 Use this step to enter a new remote access password then log the password in the box below.

REMOTE ACCESS PASSWORD:

PROGRAMMING STEP #87

ENTERS STEP NUMBER

6-DIGIT REMOTE ACCESS PASSWORD

STORES PASSWORD - 1 BING

DURESS CODE

✦The duress code will disarm the system, without any special indications or sounds, but will send the programmed duress code to the Central Station. The code should be two or more digits different than any user code

STEP #92 Use this step to enter the duress code then log the code in the box below.

DURESS CODE:

PROGRAMMING STEP #92

ENTERS STEP NUMBER

1-5 DIGIT DURESS CODE (3-5 DIGITS RECOMMENDED)

STORES CODE - 1 BING

MASTER USER CODE

✦The master user code is 1234 when power is first applied to the Control Panel.

✦The master user code can be changed to any

1-5 digit code. Only the master user can access Setup Mode, restricted users cannot.

✎NOTE: For maximum security, a 3-5 digit code is recommended.

STEP #99 Use this step to enter the new master user code then log the code in the box below.

MASTER USER CODE:

PROGRAMMING STEP #99

ENTERS STEP NUMBER

1-5 DIGIT MASTER CODE (3-5 DIGITS RECOMMENDED)

STORES CODE - 1 BING

34