14.COMMUNICATOR PROGRAMMING
✦To perform any of the advanced programming steps, the system must be in the Setup Mode.
✦Each programming function is performed with similar keystrokes. After the system is in Setup Mode, enter the programming step number and press HOME, then enter the new value and press AWAY. For reference, follow the figures next to the programming steps.
✴If the new value is accepted, a “Bing” will sound. If the new value is not accepted, a “Double Buzz” will sound.
SETUP MODE
1.Start with the system in Test Mode (Setup Mode cannot be reached from any other mode).
2.From Test Mode, enter the master user code then press TEST.
✎NOTE: Only the master user code can be used to put the system into the Setup Mode. The restricted user codes cannot access Setup Mode, only Code Mode.
✴A “Gong” and fi ve “Beeps” will sound, signaling that the system is in Setup Mode.
3.After programming changes are complete, press the OFF key for three seconds to exit Setup Mode.
✎NOTE: If the system is left unattended in Setup Mode, it will automatically switch back to Off Mode after three minutes.
ENTERS PROGRAM STEP NUMBER TO MODIFY
STORES NEW VALUE
START IN TEST
MASTER
USER
CODE
1 GONG & 5 BEEPS (SETUP MODE)
GENERAL COMMUNICATOR OPTIONS
STEP # | PROGRAMMING |
| POSSIBLE | FACTORY | INSTALLATION |
| FUNCTION |
| VALUES | VALUE | VALUE |
|
|
|
|
| |
76 | 0= NONE; 1 = LISTEN; 2 = | 0 |
| ||
|
|
|
|
|
|
78 | VOICE RESPONSE FROM KEYPAD SPEAKER | 0 | = VOICE RESPONSE DISABLED | 0 |
|
1 | = VOICE RESPONSE ENABLED |
| |||
|
|
|
| ||
|
|
|
|
|
|
100 | REMOTE PROGRAMMING LOCKOUT | 0 | = UNLOCK; 1 = LOCK | 0 |
|
|
|
|
|
|
|
101 | CALL LIMITER | 0 | = OFF; 1 = FIVE CALLS PER ARMING PERIOD | 0 |
|
|
|
|
|
|
|
103 | DIALING DELAY | 0 | = NO DELAY; 1 = 30 SECOND DELAY | 0 |
|
|
|
|
|
|
|
104 | DIALING METHOD | 0 | = TONE; 1 = PULSE | 0 |
|
|
|
|
|
|
|
107 | COMMUNICATOR ENABLE | 0 | = COMMUNICATOR OFF; 1 = COMMUNICATOR ON | 0 |
|
|
|
|
|
|
|
General Communicator Programming Table
36
