Minolta CF3102, CF2002 manual Measure margin a from the edge

Printer Panel 1

	7. Measure margin a from the edge of the
	paper to the pattern printed in the test page,
a	and then check that the width of the mea-
	sured margin meets its standard width.

Standard width of the margin (a):

3.0 mm ± 1.0 mm

Paper Exit

DirectionIf the width of the measured margin does not meet its standard width, follow the procedure in the next section, follow the instructions described below. Position for PF-118, to adjust it.

C4658U028AA

8.Select the paper drawer that you wish to adjust, and then click the up and down arrows in the lower-right corner of the screen to enter the difference between the mea- sured width and the standard width.

9.Print a test page and check the paper refer- ence position.

If the width of the measure margin does not meet its standard width, follow the instruc- tions described below.

10. Open the paper drawer for the cassette that needs to be adjusted, and then remove all of the paper.

11. Loosen the two screws on the guide plate at the bottom of the paper drawer.

C4658U024AA

12. Adjust the guide plate to the appropriate

position on the scale inside the paper drawer.

C4658U025AA

13.Check that the message displayed in the printer panel changes from “Alert Printing suspended” to “Info”.

14.Exit the External Panel Controller.

4581-7777-01 – 28 –