03_NVspec_ver304e
18Initialize Start Time
network input config SNVT_time_sec nciInitStartTm
This configuration property defines the time to start the output when the output network variables change at LM ADAPTER power ON.
The objective network variables are given below. ・nvoOnOff_n（On/Off run state）
・nvoMode_n（Mode state） ・nvoSetP_n（SetPoint state） ・nvoAlarm_n（Alarm state） ・nvoErrCode_n（Error Code）
・nvoErrAdrs_n（Error Unit Address）
・nvoThermoSt_n（Thermo On/Off state_1） ・nvoThermo_n（Thermo On/Off state_2） ・nvoAllOnOff（Collective On/Off state）
・nvoAllOff（Emergency state）
・nvoAllAlarm(Collective Alarm for Indoor Unit)
・nvoAllAlarmLMAP(Collective Alarm for LM ADAPTER)
Valid Range
The valid range covers from 0.0,1200.0 to 3600.0 seconds (per 60 seconds).
The setting to 0.0 or 6553.5 seconds makes the initial output time setting invalid.
The setting to 0.1 - 1199.9 seconds results in 1200.0 seconds.
The setting to 3600.1 ～ 6553.4 seconds results in 3600.0 seconds.
Default Value
6553.5 seconds (Setting invalid)
- 38 - |