Mitsubishi Electronics LMAP03U-E AppendixA:Fahrenheit conversion of Centigrade data, Room air, Temperature, setting range

AppendixA:Fahrenheit conversion of Centigrade data

The type of the network variable of the temperature currently used by LM ADAPTER is SNVT_temp_p, and expresses temperature data with Centigrade.By local remote controller or the system controller, the Fahrenheit is used for a temperature display and Centigrade data is used for communication between units.

The conversion table of the Fahrenheit and Centigrade is shown in Table-1.

The network variables and configuration properties which use this conversion table are as follows.

SetPoint			- nviSetP_n
SetPoint state			- nvoSetP_n
Space Temperature			- nvoSpaceTemp_n
Lower Setpoint Cooling			- nciCoolLrSetP
Upper Setpoint Heating			- nciHeatUpSetP
			Table-1
		Conversion table for C/F
	Centigrade		Fahrenheit	Room air temp.
	value(℃）		value(°Ｆ)	Temp. setting
	39		102
	38		100
	37		99
	36		97	Room air
	35		95	Temperature
	34		93
	33		91
	32		89
	31		88
	30		87
	29		85
	28		83
	27		81
	26		79
	25		77	Temperature
	24		75
	23		73	setting range
	22		71
	21		69
	20		(68)*1
	19		67
	18		65
	17		63
	16		61
	15		59
	14		57
	13		55
	12		53
	11		52
	10		50
	9		48
	8		46
	7		45
Room air temperature display range				46°F to 102 °F
Temperature setting range				63°F to 87°F
				*Cool/dry operation:67 °F to 87°F

Heat operation : 63°F to 83°F

Auto operation : 67°F to 83°F

*1:68-degree-F use only a room air temperature display.

A temperature setup cannot be performed on the controller. Moreover, it is referred to as 67-degree-F when 20-degree-C is receive.

Cautions

-Local remote controller and the temperature display of a system controller will be 2-degree-F unit.

-When the conversion formula of the Fahrenheit and Centigrade is used, an error arises.