Motorola GT10 5.3.4Setting Mode: “Liquid Crystal Display Contrast Adjustment” (Contrast), SHORTCUTS, EXPLANATION, Format: Transmission format

GT10/GT30 5.3 Entering Configuration Settings from the GT10

Procedure for bringing up the screen [Initial screen]

↓

[Setting]

↓

[TOOL Port]

Through function: Through function destination setting

When the through function is being used, this specifies the number of the PLC at the other end of the connection. Normally, when used in a 1 : 1 configuration, this should be set to “00”.

Bitrate: GTWIN communication speed

Each time the [Function] key is touched, the Baud rate switches in the sequence of 9600/19200/115200 bits/s. Set the speed to match that of the personal computer (GTWIN) connected to the GT10.

Format: Transmission format

This sets the communication parameters (data length, stop bits, parity) for the personal computer (GTWIN) connected to the GT10.

The items displayed are: Data length / Stop bit / Parity, and each time the [Function] key

is pressed, the display switches in the sequence of: [8/1/None], [8/1/Odd], [8/1/Even].

SHORTCUTS

[RETURN]To complete the settings and return to the previous screen, touch the [ESC] key.

EXPLANATION

TOOL Port communication parameter settings

The default (initial) values for the TOOL Port communication parameter settings are: 19200 bits/s, 8/1/Odd.

5.3.4Setting Mode: “Liquid Crystal Display Contrast Adjustment” (Contrast)

Touching [Setting] on the initial screen of the system menu and then the [Contrast] key of the setting mode menu displays the contrast adjustment screen. The contrast of the GT10 LCD is adjusted here.

Contrast adjustment screen

Procedure for bringing up the screen [Initial screen]

↓

[Setting]

↓

[Contrast]

87