Motorola GT10 2.3Wiring the COM. Port, Accessory communication connector, Applicable wiring (twisted wiring), Crimp tools for stick–typeterminals

GT10/GT30 2.3 Wiring the COM. Port

2.3Wiring the COM. Port

Accessory communication connector/applicable wiring

The communication connector used for the COM. port (provided as an accessory with the main unit) has a screw–tightening type of terminal base. The wiring shown below should be used.

Accessory communication connector

The communication connector is made by Fenics Contact Co., Ltd.

No. of pins	Fenics Model No.
	Model No.	Product No.
5–pin	MC1, 5/5–ST–3,5	1840396

Applicable wiring (twisted wiring)

Size	Conductor Cross–Section Surface Area
AGW#28 to 16	0.08 mm2 to 1.25 mm2

Applicable stick–type terminals with insulated sleeves

If stick–type terminals are used, the models listed below are marketed by Fenics Contact Co., Ltd.

Maker	Cross–Section Surface	Size	Fenics Co. Model
	0.25 mm2	AGW#24	AI 0,25 to 6 YE
Fenics Contact	0.50 mm2	AGW#20	AI 0,50 to 6 WH
Co., Ltd.	0.75 mm2	AGW#18	AI 0,75 to 6 GY
	1.00 mm2	AGW#18	AI 1 to 6 RD

Crimp tools for stick–type terminals

Maker	Fenics Model No.
	Model No.	Product No.
Fenics Contact Co., Ltd.	CRIMPFOX UD6	1204436

Use a special tool to tighten the terminal base of the communication connector

Tightening of terminals should be done using a screwdriver made by Fenics Contact Co., Ltd. (Fenics mfg. no. 1205037, blade width 0.4 x 2.5, model no. SZS 0.4 x 2.5), or a screwdriver made by Matsushita Electric Works Co., Ltd. (Product number AFP0806). The tightening torque should be 0.22 N·m to 0.25 N·m or less.

23