Motorola GT10 4.11 Connecting with a PLC by Mitsubishi Electric Corp, 4.11.1FX Series, Making connections, Devices that can be used, Setting the communication conditions

GT10/GT30 4.11 Connecting with a PLC by Mitsubishi Electric Corp.

4.11 Connecting with a PLC by Mitsubishi Electric Corp.

4.11.1FX Series

GT10

FX series of PLCs by		GT30
	Adaptor
Mitsubishi Electric
Corporation

Making connections

CPU	Adaptor	Wiring diagram				GT series
FX1N	FX1N–232–BD	Mitsubishi PLC adaptor side		GT main unit side		GT10/GT30
		Pin no.	Abbreviation	Pin no.	Abbreviation
		1	CD	SD	SD
		2	RD	RD	RD
		3	SD	RS	RS
FX2N	FX2N–232–BD	4	ER	CS	CS
		5	SG	GND	GND
		6	DR
		7
		8
		9

*Be aware that communication will not be possible if the above adaptor cannot be connected to the FX series.

Setting the communication conditions

Setting the communication conditions for the GT main unit

The following settings should be entered for the COM port communication condition settings.

Item	Value Set
Communication speed setting	9600 bits/s
Data length	7 bits
Parity check	Yes, Even
Stop bits	1 bit

Setting the communication conditions for the PLC

“0” should be stored in D8120. (“0” is the default value, so this setting should not need to be entered by the user.)

Devices that can be used

Device type	Address range	Points
Input relay	X000 to X377 (Octal notation)	256 points
Output relay	Y000 to Y377 (Octal notation)	256 points
Auxiliary relay	M0000 to M1535 (Decimal notation)	1536 points
Data register	D0000 to D1023 (Decimal notation)	1024 words

62