Motorola GT10 3.3Setup Procedure for the GT30, (2) Connect the GT30 and the personal computer, (1) Setting the “Configuration File” with GTWIN

GT10/GT30 3.3 Setup Procedure for the GT30

3.3Setup Procedure for the GT30

The GT30 should be set up using the procedure outlined below.

(1) Setting the “Configuration File” with GTWIN

The GT30 has an internal file called the “Configuration file”, which is used to determine various operating environment parameters. When the GT30 is shipped from the factory, the settings listed below are set for the parameters in the configuration settings file. If changes are made to these settings, they are made from GTWIN screen creation tool. (For detailed information on changing settings, see page 109 and subsequent pages.) If the GT30 is being used without changing the factory settings, the following setup procedure is not necessary.

Contents of configuration settings for GT30 when shipped from the factory

Classification	Item	Setting contents
Basic Setup	Area for basic	Word area: DT0 to DT2
	communication	Bit area : WR0 to WR2
	with PLC
		Communication speed: 19200 bits/s, data length: 8 bits, stop bit: 1 bit, parity: odd
Communication	COM. port	<Communication error temporary processing> Retries: 3, error code displayed
parameter		(not held)
settings	TOOL port	Communication speed: 19200 bits/s, data length: 8 bits, stop bit: 1 bit, parity: odd
		<Through function local setting> None
Auto paging	Automatic paging	No
Startup screen	Startup screen	No. 00
settings	Rise delay time	0 seconds
	Clock	GT main unit clock / external transmission: No
Other settings	Backlight control	Not turned off automatically
	Touch operation	Valid
	sounds
Hold PLC Device	Holds a PLC device	Not held
GT internal	GT internal device	Not held
device hold	hold

Always confirm “Basic communication area to PLC” under “Basic Setup”

This is an internal device area that comes already provided in the GT30 for the purpose of communicating with a PLC. If the factory settings are to be changed, the setup procedure must be carried out. For detailed information, please see page 37.

(2) Connect the GT30 and the personal computer.

After the settings have been entered with GTWIN, connect the computer and the GT30, using the screen transfer cable.

GTWIN

Screen transfer	GT30
cable (AFC8513D)

34