Motorola GT10 4.5Connecting the FP2/FP2SH CCU, Connecting to the FP2 computer communication unit (CCU), PLC communication cable: D–sub 9–pin loose–wirecable (AIP81842D)

GT10/GT30 4.5 Connecting the FP2/FP2SH CCU

4.5Connecting the FP2/FP2SH CCU

GT10

FP2 computer communication unit

AIP81842DGT30

DIP switch settings on reverse side of FP2 computer communication unit

SW No.	Setting contents	Value Set	Switch status
1	Reserved for system		ON
2	COM.1 transfer speed	19200 bits/s	ON
3			OFF
4	COM.1 data length	8 bits	ON
5	Reserved for system		ON
6	COM.2 transfer speed	19200 bits/s	ON
7			OFF
8	COM.2 data length	8 bits	ON

If both serial ports of the FP2 computer communication unit are being used, each port should be set individually as shown at the left.

With the FP2 CCU, the parity check is fixed at “Odd”, and the number of stop bits is fixed at “1 bit”.

PLC communication cable: D–sub 9–pin loose–wire cable (AIP81842D)

	2000mm	Signals on D–sub side
	35mm	Pin no.	Wire color		GT COM port
	5mm	1		––	––
		2		White	RD
	1
6		3		Green	SD
	2
7		4			––
	3
8	4	5			––
9
	5	6		––	––
	Wires’ cross section: 0.25mm2	7		Brown	GND
		8		––	––
		9		––	––
		Specifications		Length	Product no.
		D–sub 9–pin		2m	AIP81842D
		Single–side
		loose wiring

Connecting to the FP2 computer communication unit (CCU)

	Pin no. on PLC side		GT10/GT30	PLC side	Abbreviation
		No. 3 (green)		Pin no.
	1			1	FG
6		No. 2 (white)		2	SD
7	2			3	RD
	3
8				4	RS
	4	No. 7 (brown)
9	5			5	CS
				6	N.C.
				7	SG
				8	N.C.
				9	ER

GT main unit side

Pin no.	Abbreviation
SD	SD
RD	RD
RS	RS
CS	CS
GND	GND

51