Troubleshooting 6-17

a-5. The message of update completion will be displayed. "[Update of the driver Completion]

Press any key and terminate."

b) When N8803-031F (Fibre Channel Controller) is connected

b-1. Start up [Device Manager] by selecting [Start] - [All Programs] - [Administrative Tools] - [Computer Management].

Check to see [Qlogic QLA23xx PCI Fibre Channel Adapter] appears under [SCSI and RAID Controllers].

You do not need to perform the steps b-2 and later if the number of [Qlogic QLA23xx PCI Fibre Channel Adapter]s shown is identical to number of actually implemented [Qlogic QLA23xx PCI Fibre Channel Adapter]s. If not, go to b-2.

b-2. Right-click the [Unknown Device] – [Fibre Channel Controller] on the [Device Manager], and select [Update Driver].

b-3. Select [Install from a list of specific location (Advanced)], and then click [Next].

b-4. Select [Don’t search. I will choose the driver to install.], and then click [Next].

b-5. Select [SCSI and RAID Controllers], and then click [Next].

b-6. Do not select a driver on the model list. Click [Have Disk…].

b-7. Insert NEC EXPRESSBUILDER into the CD-ROM drive and click [Browse]. Specify the “CD-ROM drive:\WINNT\DRIVERS\QL2300” folder in the “Copy manufacture’s files from:” column, and then click [OK].

b-8. Select [Qlogic QLA23xx PCI Fibre Channel Adapter] on the model list and click [Next].

b-9. A warning message tells that you are about to update a driver. Click [Yes] to continue. The driver will be installed. During the processing, the mouse cursor may not be moved for 10 to 20 seconds. Please wait.

b-10. Click [Finish].

b-11. Check to see that the number of [Qlogic QLA23xx PCI Fibre Channel Adapter]s shown is identical to number of actually implemented [Qlogic QLA23xx PCI Fibre Channel Adapter]s. If not, repeat the steps 2 to 10.

c)When N8104-84 (1000BASE-SX Adapter) is connected c-1. Execute [Command Prompt].

c-2. Run the following command from Command Prompt and move to CD-ROM drive.

C:\> CD-ROM drive:

c-3. Run the following command from Command Prompt and move to the folder with the batch file.

CD-ROM drive:\> cd \WINNT\DOTNET\EN

c-4. Run the following command from Command Prompt for updating the driver. CD-ROM drive:\WINNT\DOTNET\EN> N810484.BAT

c-5. The message of update completion will be displayed. "[Update of the driver Completion]

Press any key and terminate."

d)When N8104-103 (1000BASE-T Adapter) is connected

d-1. Execute [Command Prompt].

d-2. Run the following command from Command Prompt and move to CD-ROM drive.

C:\> CD-ROM drive: