(2)Make sure that the two BMC Status LEDs of the PCI modules (for Group1/for Group2) are turned off.
IMPORTANT: While the BMC Status LED is red and blinking, do not perform
(3)and on. Otherwise the BMC firmware may become damaged.
(3)Remove the power cord of the AC inlet A (for Group2).
(4)Check that the POWER switch of the PCI module for Group1 is turned on.
(5)Connect the power cord of the AC inlet A (for Group2).
(6)Make sure that two BMC Status LED for PCI modules (for Group 1/for Group 2) are turned off.
IMPORTANT: If the BMC Status LED is red and blinking, start the ft series setup after the LED is turned off. Otherwise the setup may not be done properly.
Preparation is now completed. Start the ft series setup.