4-20Windows Setup

CD-ROM and NEC EXPRESSBUILDER will be started.

13. After the system is restarted, the following message will appear:

If you have an additional ft Update CD and wish to use it, insert the CD-ROM into the CD-ROM drive.

Use an additional ft Update CD [Y,N]?

If you have “NEC Express5800/ft series ft Update CD” handy, enter “Y”.

If you do not have “NEC Express5800/ft series ft Update CD” handy and perform installation using “NEC EXPRESSBUILDER” only, enter “N”.

14.A message for reconfirming usage of the “NEC Express5800/ft series ft Update CD” will appear. Enter “Y” if the selection is correct. Enter “N” if it is wrong.

The additional ft Update CD will be used. Are you sure [Y,N]?

Or

The additional ft Update CD will not be used. Are you sure [Y,N]?

15. <Only when the usage of the “NEC Express5800/ft series ft Update CD” is selected>

The message below will appear. Insert ft Update CD into CD-ROM drive and press Enter key.

If you have an additional ft Update CD and wish to use it, insert the CD-ROM into the CD-ROM drive.

Use an additional ft Update CD [Y,N]?Y

The additional ft Update CD will be used. Are you sure [Y,N]?Y

Insert the ft Update CD into the CD-ROM drive and press ENTER.

IMPORTANT: When the usage of the “NEC Express5800/ft series ft Update CD” is not selected, the above message will not appear. Go on to 11.

16.<Only when the usage of the “NEC Express5800/ft series ft Update CD” is selected> The message below will appear. Wait about 3 minutes until copying is completed.

Copying necessary NEC Express5800/ft series system software to the system drive... Approximately 3 minutes.

Necessary NEC Express5800/ft series software has been copied.