NetComm NP3640 manual TCP/IP Tab

TCP/IP Tab

Selecting this tab will allow configuration for the TCP/IP network protocol. The basic options are:

■Dynamic IP Address (DHCP) - The IP address is obtained automatically, from a DHCP Server on your network.

■Fixed IP Address - You must enter the IP address, Subnet Mask, and Gateway Address.

■IP Address - Select an unused IP address from the address range used on your LAN.

■Subnet Mask - Use the same values as computers on your LAN (or on the same LAN segment, if you have a Router).

■Gateway - Use the same values as computers on your LAN (or on the same LAN segment, if you have a Router).

Some Print Server models also support the Auto-IP function. If the Print Server is set to Dynamic IP Address, but there's no DHCP server found on the network, the Print Server will get an IP from the range of 169.254.1.1 ~ 169.254.254.254 automatically. In this case, even though the Print Server was initialized with an Auto-IP, it will change to DHCP whenever a DHCP server is detected.

The TCP session parameters should only be changed if advised to do so by your Network Administrator or Print Server Technical Support.

www.netcomm.com.au	Rev. 1 - YML657
Page 30	NP3640 Fast Ethernet Mini Print Server User Guide