NetComm NP3640 Connecting your Mini Print Server, Preparation, Connect the Printer, Power Up

Section 2 - Connecting your Mini Print Server

This section describes how to install the Print Server in your Local Area Network.

1.Preparation

■Ensure the power is OFF. Do not connect the Print Server while power is On.

■Find the Default Server Name for your Print Server. The Default Server Name is shown on a sticker on the base of the device. It consists of 8 letters and/or digits. Record this name; it may be needed during configuration.

2.Connect the Printer

Connect the printer or plotter by plugging Print Server directly into the parallel port on the printer.

3.Connect the Network Cable

■Connect the network cable to the proper connector on the Print Server. The Print Server will automatically recognize whichever connector is used.

4.Power Up

Plug in the power adapter cable and power up. Start-up will take only a few seconds.

5.Check the LEDs

■The Red Error LED should flash, then turn Off. When the Red LED goes off and the Green LED remains lit or flashes, the Print Server is ready.

■If your model supports 10BaseT and 100BaseT, check the 10/100BaseT link LED or LEDs next to the LAN connection. If the auto negotiation Fails, the LED (or both LEDs, if there are 2) will be Off.

www.netcomm.com.au	Rev. 1 - YML657
Page 4	NP3640 Fast Ethernet Mini Print Server User Guide