Diagnostic Push Button
The Print Server is fitted with a Diagnostic Push Button. The button is recessed; a pin or paper clip can be used to press it. This button has 2 functions:
■Restore the factory default settings
■Print a test page containing all current settings. To restore the factory default settings:
1.Turn the Print Server OFF.
2.Press and hold the diagnostic button. While pressing the button, switch the Print Server ON.
3.If you continue pressing the button for 10 seconds, a diagnostic page will be printed, showing the new (default) settings.
To generate a Diagnostic print out
1.Ensure that both the Print Server and the printer attached to port 1 are ON.
2.Press the diagnostic button, and hold it in for 2 seconds.
3.The test page, containing the current settings, will be printed.
Note: PostScript printers are unable to print this page. If you have a PostScript printer on Port 1, the test page will not be printed.
LED Indicators
The Mini Print Server has four LED indicators; status, error, 10 BaseT and 100BaseT. The LED indicator modes are described in the following table:
Green LED | Red LED | Description |
Off | Off | No power. |
Off | On | Printer not on. |
On | On | Hardware error. |
Flashing | Flashing | Firmware upgrade in progress. |
On | Off | Normal operation. |
Flashing | Off | Normal operation - transmitting or receiving packets |
|
| from the network. |
Yellow LED | Orange LED | Description |
On | Off | Connected at 10BaseT. |
Off | On | Connected at 100BaseT. |
Rev. 1 - YML657 | www.netcomm.com.au |
NP3640 Fast Ethernet Mini Print Server User Guide | Page 5 |
