FVS338 ProSafe VPN Firewall 50 Reference Manual
Router Front Panel
The ProSafe VPN Firewall 50 front panel shown below contains the port connections, status LEDs, and the factory defaults reset button.
Power | Test | Modem | Internet | Local | |
LED | LED | LED | LEDs | ||
LEDs | |||||
|
|
|
|
Figure
The table below describes each item on the front panel and its operation.
Table 1-1. Object Descriptions
Object | Activity | Description |
|
|
|
Power LED | On (Green) | Power is supplied to the router. |
| Off | Power is not supplied to the router. |
Test LED | On (Amber) | Test mode: The system is initializing or the initialization has failed. |
| Blinking (Amber) | Writing to Flash memory (during upgrading or resetting to defaults). |
| Off | The system has booted successfully. |
|
|
|
MDM LED | On (Green) | The serial port has successfully connected to an ISP and received an |
|
| IP Address. |
| Blinking (Green) | Server data is being transmitted or received by the serial port. |
| Off | The serial port has no link. |
Internet | Link/Act LED |
|
LEDs | On (Green) | The WAN port has detected a link with a connected Ethernet device. |
| Blinking (Green) | Data is being transmitted or received by the WAN port. |
| Off | The WAN port has no link. |
|
|
|
| 100 LED |
|
| On (Green) | The WAN port is operating at 100 Mbps. |
| Off | The WAN port is operating at 10 Mbps. |
Introduction |
