FVS338 ProSafe VPN Firewall 50 Reference Manual
2-4 Connecting the FVS338 to the Internet
v1.0, September 2006
3. Click Connection Status at the top right of the screen to verify your Broadband connection
status. Click Connect if connection not already present.
If Auto Detect does not find a connection, you will be prompted to check the physical
connection between your firewall and the cable or DSL line or to check your Router’s MAC
address (see “Setting the Router’s MAC Address (Advanced Options)” on page 2-7).
4. Set up the traffic meter for ISP1 if desired. See “Programming the Traffic Meter (if Desired)”
on page 2-12.
The Dialup Settings screen will assist you in setting up the router to access the Internet connection
using a dialup modem. Since the Dialup ISP Settings must be configured manually, you will need
all of your ISP settings information before you begin.
To configure the Dialup ISP serial WAN port:
DHCP (Dynamic IP) No data is required.
Fixed IP IP address and related data supplied by your ISP.
Figure 2-3
Note: At this point in the configuration process, you are now connected to the Internet
through the broadband Ethernet WAN. Optionally, you can continue with the
configuration of the dialup ISP serial WAN interface.
Table 2-1. Internet connection methods
Connection Method Data Required