
6-4 Administration Guide
Launch your terminal emulation software and configure the communications software for the values shown in the table below. These are the default communication parameters that the Netopia 4753 uses.
Parameter | Suggested Value |
|
|
Terminal type | PC: |
| Mac: ANSI, |
Data bits | 8 |
Parity | None |
Stop bits | 1 |
Speed | 9600 bits per second (can be set for up to 57600) |
Flow Control | None |
|
|
Note: The router firmware contains an autobaud detection feature. If you are at any screen on the serial console, you can change your baud rate and press Return (HyperTerminal for the PC requires a disconnect). The new baud rate is displayed at the bottom of the screen.