Nokia E51 manual Write text, Traditional text input, Eject the memory card

Your Nokia E51

30

Options > Set password. The password can be up to eight characters long and is case-sensitive. The password is stored in your device. You do not need to enter it again while you use the memory card in the same device. If you use the memory card in another device, you are asked for the password. Not all memory cards support password protection.

To remove the memory card password, select Options > Remove password. When you remove the password, the data on the memory card is not protected against unauthorised use.

To open a locked memory card, select Options > Unlock memory card. Enter the password.

Eject the memory card

Important: Do not remove the memory card in the middle of an operation when the card is being accessed. Removing the card in the middle of an operation may damage the memory card as well as the device, and data stored on the card may be corrupted.

1.Press the power key briefly, and select Remove memory card.

2.Press the release button and slide off the back cover.

3.Press the end of the memory card to release it from the memory card slot.

4.Close the back cover.

Write text

The input methods provided in the device may vary according to different sales markets.

Traditional text input

is shown on the top right of the display when
you are writing text using traditional text input.
and	indicate the selected case.
indicates that the first letter of the sentence is written
in uppercase and all the other letters are automatically
written in lowercase.		indicates the number
mode.

To write text with the keypad, press a number key

2-9repeatedly until the desired character appears. There are more characters available for a number key than are printed on the key. If the next letter is located on the same key as the present one, wait until the cursor appears, and enter the letter.

To insert a number, press and hold the number key. To switch between the upper and lower case mode and the number mode, press #.

To erase a character, press the backspace key. Press and hold the backspace key to erase more than one character.

To access the most common punctuation marks, press the 1 key. Press 1 repeatedly to reach the desired punctuation mark.