
56Configuration
Variable | Value |
|
|
Sets the peer IP address on the | |
|
|
|
|
pppfile <file> | Identifies the file to use for PPP initialization |
| parameters. |
|
|
Procedure job aid:
Table 3
| Switch | Modem |
|
Signal |
|
|
|
Pin | DCE | DCE | |
| number | pin number | pin number |
|
|
|
|
RXD | 2 | 2 | 3 |
|
|
|
|
TXD | 3 | 3 | 2 |
|
|
|
|
DTR | 4 | 4 | 20 |
|
|
|
|
GND | 5 | 5 | 7 |
|
|
|
|
DSR | 6 | 6 | 6 |
|
|
|
|
RTS | 7 | 7 | 4 |
|
|
|
|
CTS | 8 | 8 | 5 |
|
|
|
|
Connecting a modem using the NNCLI
Connect a modem to a Ethernet Routing Switch 8600 to establish a connection with the switch. To connect a modem to an Ethernet Routing Switch you may need to set up the modem port using another type of connection, such as a terminal connection, to the NNCLI.
You can access the NNCLI through a modem connection to the Ethernet Routing Switch 8690SF, 8691SF/CPU, or 8692SF/CPU modules.
ATTENTION
Nortel recommends that you use the default settings for the modem port for most modem installations.
Prerequisites
•You need a
•You must configure your client
•You must log on to the Global Configuration mode in the NNCLI.
Nortel Ethernet Routing Switch 8600
Quick Start
30 May 2008
Copyright © 2008 Nortel Networks