Tape management information
This unit automatically stores as the tape management information both the frame rate information which indicates the shooting speed and the active frame information which indicates the first frame where the frame image was switched in the user’s bit of the
Example of display
LTC user’s bit
O When the internal colour bar signals are being recorded
User’s bit setting
Frame frequency
5:59.94 Hz
6:60.00 Hz
Tape management information
OActive frame information
OREC START/STOP mark
VITC user’s bit
User’s bit setting
Tape management information
LTC user’s bit verification information
0 1 : 1 2 : 0 1 : x x
To verify the VITC user’s bit, set the DISPLAY switch to UB, and hold down the HOLD button. While the HOLD button is held down, the VITC user’s bit information appears on the counter display.
0 1 : 1 2 : 0 1 : 5 0
O When the camera’s video signals are being recorded
Recorded frame number count
This indicates the number of frames recorded.
When the frame rate has been set to 24 fps and recording has been performed for 10 seconds, “0240” will be displayed as the count. When recording is started, the count is reset to “0000,” and the number of recorded frames per cut is counted up to “9999.”
Frame rate information
24fps (23.98 fps)
Frame frequency
5:59.94 Hz
6:60.00 Hz
Tape management information
OActive frame information
OREC START/STOP mark
0 2 : 4 0 : 2 4 : 5 0
