Connection with a PC in the USB DEVICE mode
By connecting
Procedures for establishing a connection with a
PC
1 Connect the USB cable to the USB 2.0 port.
Notes
zThe USB 2.0 cable is not included with the camera- recorder. Please use a commercially available USB 2.0 cable (shield with a ferrite core).
zAlthough the unit supports USB cables up to 5 meters long, cables up to
Notes
zA USB driver must be installed on the PC.
z
zOnly one unit at a time must be connected to the PC via USB.
zThe P2 card must not be removed when it is connected via USB.
zWhile a USB connection is established, the P2 card’s access LED should not be lit except when access is being carried out.
zWhen a USB device is active, recording, playback, or navigation through clip thumbnails is disabled.
During a USB connection, the USB LED on the side panel stays illuminated. Also, “USB DEVICE” is displayed in the system information/warning area in the viewfinder.
When the connection is not correctly established, both of these indications blink.
device external with Connection
USB 2.0 port (DEVICE)
2 Navigate the menu to open the SYSTEM MODE screen on the SYSTEM SETTING page. Then, set the PC MODE SELECT menu option to USB DEVICE and the PC MODE option to ON.
#< SYSTEM MODE >
SYSTEM MODE | |
REC SIGNAL | :CAM |
CAMERA MODE | :60i |
VF TYPE | :HD |
PC MODE SELECT | :DEVICE |
# PC MODE | :ON |
Note
The function of the menu option USB may be assigned to a desired user button by using any one of the menu options USER MAIN SW, USER1 SW or USER2 SW.
These options can be found in the USER SW screen, which is accessible from the CAM OPERATION page.
When you establish the USB connection for the first time, install the accessory P2 software for
USB LED
$*
)
)#$%
3 There are two ways to terminate the USB mode, as follows:
zTurn the POWER switch of
zSet the PC MODE item to “OFF” from the menu operations.
Connection with external device : Connection with external devices using the USB 2.0 port 131