6 Select YES to start writing data to the cards.
<For your information>
To disable verification during writing, select HDD > SETUP from the thumbnail menu and set the option VERIFY to OFF. This speeds up writing without verifying data writing.
7 When the writing is completed, the message “COPY COMPLETED!” is displayed.
Note
If a clip is written back to a P2 card different from the original card that contained that clip, then the clip may be incomplete. If this is the case, reconnect the clip. For more information, see [Reconnection of Incomplete Clips] (page 118).
Direction for using a hard disc drive
zA hard disc drive must be used under the following conditions:
It must meet the operating requirements (e.g. temperature).
It must not be placed in an instable place or a place exposed to vibrations.
zSome hard disc drives do not operate properly.
zSome hard disk drives with the SATA (Serial ATA) interface or the PATA (Parallel ATA) interface connected by a USB conversion cable may not be recognized.
zWhen copying data, a hard disc drive must have sufficient free space.
zDo not remove the cable or the target P2 card or turn off the
zSince hard disc drives are high precision devices, there is a high possibility that they may become incapable of writing data depending on the conditions of use.
zTake note that we will not be liable for loss of data caused by failed hard disc drives or any other problem as well as direct or indirect damages resulting from the loss of data.
zWe do not guarantee that hard disc drives will operate properly with the
zBy using the drive mount converter distributed on the following URL, the hard disk drive can be mounted in the designated folder when connected.
136 Connection with external device : Connection with external devices using the USB 2.0 port