Connection using the SDI IN connector

(when AJ-YA350AG attached)

1 Confirm that the HD/SD-SDI input board (AJ- YA350AG: optional accessory) is attached to the unit and that the wires are connected properly. For details, refer to the installation manual for the AJ-YA350AG.

2 Confirm that the connected device has the same signal format as camera-recorder.

3 When signals are input from the SDI IN connector, set the REC SIGNAL in the setting menu to “SDI”. The REC SIGNAL item will be selected from <SYSTEM MODE> on the SYSTEM SETTING page.

‹Notes

zIf the HD/SD-SDI input board is not attached, REC SIGNAL cannot be set to "SDI".

zWhen nothing is connected to the SDI IN connector or there is no input signal, images to be recorded will be black and no sound will be recorded. Input the same signals as the format set in the SYSTEM MODE item in the setting menu through the SDI IN connector. If the formats are different, data will not be properly recorded on the P2 card.

zNote the following points when the REC SIGNAL of the setting menu is set to “SDI”.

ŠAudio signals are input from the SDI IN connector.

ŠAudio signals must be input synchronized with video images. Data will be recorded as 48 kHz/4CH (16 bit) on a P2 card.

ŠWhen the REC SIGNAL item is set to “SDI”, signals input from the GENLOCK IN connector are disabled even if nothing is connected to the SDI IN connector. Please note that there is a delay between video images and voice signals when the unit is used on a system synchronized with the reference.

zUMID information, time code and user bits cannot be recorded on a P2 card using the SDI IN connector.

device external with Connection

Connection with external device : Connection using the SDI IN connector (when AJ-YA350AG attached) 137