Chapter 3 Recording and Playback (continued)

3-2 Basic Procedures

This section describes the basic procedure for shooting and recording. Before you embark on a shoot, pre-inspect your system to ensure that it works properly.

*For directions on inspecting your memory card camera-recorder, see [7-1 Inspections Before Shooting].

Battery Set-up to P2 card Insertion

1Insert a charged battery pack.

2Turn on the POWER switch and ensure that more than four segments of the battery-remaining amount indication bar are illuminated.

z If the number of illuminated segments is fewer than five, first check the battery placement. If placement is not the problem, replace the battery with a fully charged one.

3Insert a P2 card and ensure that the P2 CARD ACCESS LED stays on in orange or green. Then, close the slide-out door.

When more than one P2 card slot contains a P2 card, the card in the slot with the lowest number is used first. However, regardless of slot number, a P2 card inserted later will not be accessed until the other cards have been used.

Example:

If all five slots contain P2 cards, the cards are used in order of slot numbers 12345. However, if the P2 card in Slot 1 is removed and then re-inserted, the cards will be used in the following order: 23451.

2

2

1

3

5 4 3 2 1

Note that the recording order is retained even if the power is turned off. When the power is next turned on, the last card written before powering-down will be the target card.

<Note>

When “SLOT1” is selected for the menu option P.ON REC SLOT SEL, recording starts from the P2 card inserted in the smallest slot number, after the power is turned on.

This option is found in the REC FUNCTION screen on the SYSTEM SETTING page.

Switch Setting

When a battery and P2 cards are installed, set the switches as detailed below, before starting to use your AJ-SPC700P.

Setting the switches before shooting and recording

USER MAIN:

AUDIO SELECT

This switch is factory-set to

CH 1/CH 2:

perform slot selection.

AUTO

TCG:

F-RUN or

R-RUN

OUTPUT:

CAM/AUTO KNEE ON

GAIN:

Normally, this should be set to 0 dB. If

Iris: Auto conditions are too dark, an appropriate gain level should be set.

<Notes>

zThe USER MAIN button is factory-set to perform the slot selection function, which selects the target card from among several P2 cards.

When a new target P2 card is selected, the appropriate slot number appears on the P2 card remaining amount indicator in the viewfinder.

For more information about the indications in the viewfinder, see [4-7-2 Viewfinder Status Indication Layout].

zSLOT SEL function is enabled during recording; however, a few seconds are required for switching slots. When the target P2 card is switched during recording, further switching to a different P2 card cannot be accepted for over ten seconds after the first switch.

zThe ability to switch to a different target P2 card using the SLOT SEL function is not available over ten seconds after recording starts.

zWhen a Voice Memo is recorded simultaneously with the video and sound, video and sound recording continues after switching of the target P2 card using the SLOT SEL function; however, Voice Memo recording stops.

24