Panasonic AJSPC700P manual 85

Chapter 6 Manuipulating Clips with Thumbnails (continued)

Selecting the USER CLIP NAME recording method

Select META DATA  USER CLIP NAME from the menu bar to select the recording method. Two options are available: TYPE1 and TYPE2.

z TYPE1

	USER CLIP NAME to be recorded
If clip metadata has been	Uploaded data
read in
If no clip metadata has been
read in or if the setting for	Same as GLOBAL CLIP ID
recording clip metadata has	(UMID data)
been turned off

z TYPE2

	USER CLIP NAME to be recorded
If clip metadata has been	Uploaded data
read in	+ COUNT value*
If no clip metadata has been
read in or if the setting for	Same as CLIP NAME
recording clip metadata has
been turned off

<Note>

When a P2 card with a memory capacity of 8 GB or more is used in this unit and a one-time continuous recording exceeds the prescribed duration (approx. 10 minutes for DVCPRO50 or approx. 20 minutes for DVCPRO or DV) or when a one-time recording extends over more than one P2 card, the recording concerned will automatically be undertaken as a separate clip. At this time, each clip will be provided with its own COUNT value.

Example of recording (DVCPRO50) a clip on one P2 card

REC start (recording start)			REC/PAUSE (recording pause)
		Recording duration = Approx. 15 min.
		Clip 1	Clip 2
					6
		COUNT value	COUNT value
	= 0001		= 0002
		10 min.		5 min.

Example of recording a clip on two P2 cards:

REC start (recording start) REC/PAUSE (recording pause)

*The COUNT value is indicated as a four-digit number. The COUNT value is incremented each time a new clip is captured if clip metadata has been read in and TYPE2 has been selected as the recording method.

The COUNT value can be reset using the following procedure.

Select PROPERTY  DEVICE  META DATA from the menu bar, then select USER CLIP NAME to display the menu shown below. Select “COUNT RESET” with the cursor and press the SET button to reset the COUNT value to 1.

	Clip 1	Clip 2
	COUNT value	COUNT value
= 0003		= 0004
	1st card		2nd card

If the clip thumbnails are displayed as shown in the example above or their properties are indicated using a P2 device, the thumbnail and COUNT value of clip 1 will be displayed.

Clear the uploaded metadata

Select META DATA  INITIALIZE from the menu bar, and press the SET button. Select “YES” when the confirmation screen is displayed.

6-13 Setting of Proxy (optional)

By attaching the video encoder card (AJ-YAX800G, optional) either to the optional slot or Slot 5, it is possible to specify the proxy recording setting.

Select OPERATION  DEVICE SETUP  PROXY from the menu bar to specify the setting.

For more information on settings, see the video encoder card instruction manual.

85