Chapter 5 Preparation (continued)

Using an NP-1 type battery pack

CAUTION:

These servicing instructions are for use by qualified service personnel only. To reduce the risk of fire or electric shock do not perform any servicing other than that contained in the operating instructions unless you are qualified to do so.

1Remove the battery holder.

2Mount the NP-1 type battery case on the camera- recorder.

Tighten the mounting screws. Tighten the power contact screws.

Insert the upper part of the removed cover in the direction of the arrow.

Align the holes in the bottom part (metal part) of the cover with the holes in the case, and secure the cover with the screw.

<Note>

When mounting the battery holder, take care not to pinch the connection cord.

Battery Case (for NP-1 type)

When using a V-mount type battery pack

Mount the V-mount adapter plate.

Insert the plate and slide it in the direction of the arrow.

3Setting the battery type.

Select the battery type listed under BATTERY SELECT. Select BATTERY SELECT from the <BATTERY/ P2CARD> screen on the MAIN OPERATION page.

When using a battery not listed under BATTERY SELECT: If it is a NiCD battery, select “NiCd14(14V)”, “NiCd13(13V)”, or “NiCd12(12V)”, depending on the battery voltage. Set the other items according to the battery properties. If it is not a NiCd battery, select TYPE A or TYPE B and set the other items according to the battery properties.

Please refer to [8-6-3 BATTERY SETTING2] for more information.

<Note>

For information about the V-mount adapter plate, please contact the store where you purchased the camera-recorder.

66