Chapter 5 Preparation (continued)

<Notes>

zA USB driver must be installed on the PC.

zAJ-SPC700P is only applicable to USB 2.0, not to USB 1.1.

zOnly one AJ-SPC700P at a time must be connected to the PC via USB.

zThe P2 card must not be removed when it is connected via USB.

zWhile a USB connection is established, the P2 card’s access LED should not be lit except when access is being carried out.

zWhile the USB is turned ON, operations such as recording, playback and thumbnails will not be available.

During a USB connection, “DRIVE” is lit in the status indication area of a display window. Also, “USB DRIVE” is displayed in the system information/warning area in the viewfinder.

When the connection is not correctly established, both of these indications blink.

MEDIA

E

 

 

 

 

 

 

 

F

 

 

30

 

 

 

 

 

 

 

 

 

 

 

BATT

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

E

 

 

 

 

 

 

 

 

 

 

 

 

 

F

 

 

40

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

OO

 

 

 

DRIVE

 

 

 

 

 

 

 

 

 

13 -dB24

￿￿￿￿￿￿￿￿￿￿*￿￿￿￿$￿

￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿#

￿￿￿￿￿￿)*￿￿￿￿￿!￿￿￿￿￿￿￿￿#￿￿￿￿￿￿￿￿￿￿￿%￿￿

3There are two ways to terminate the USB mode, as follows:

z Turn the POWER switch of the AJ-SPC700P OFF. z Set the USB to OFF from the menu operations.

5-6 Mounting the Camera on a Tripod

When mounting the camera on a tripod, use the tripod adapter supplied with the camera.

1Mount the tripod adapter on the tripod.

Tripod Adapter

Pan head

<Note>

Select an appropriate hole in the adapter, taking into account the center of gravity of the camera and tripod adapter combined.

Also, make sure that the diameter of the selected hole matches the diameter of the pan head screw.

2Mount the camera on the tripod adapter.

Slide the camera forward along the grooves until you hear a “click”.

Removing the Camera from the Tripod Adapter

Tripod Adapter

Red Lever

Black Lever

While holding the red lever down, move the black lever in the direction of the arrow, and slide the camera backward to remove it.

<Note>

If the tripod adapter pin does not return to its original position after the camera has been removed, hold the red lever down and move the black lever in the direction of the arrow again, in order to return the pin to its original position. Please note that the camera cannot be mounted if the pin remains in the center.

74