Chapter 5 Preparation

5-1 Power Supply

A battery pack or an external DC power supply can be used as this unit’s power supply.

2Insert the battery and slide it in the direction of the arrow.

Using a Battery Pack

Battery packs from the following manufacturers can be used:

•Anton/Bauer

•IDX

•PACO

•Sony

<Notes>

zOther batteries may be used by changing the menu setting, but system compatibility is not guaranteed.

zCharge the battery pack with the battery charger before using it. (Please refer to the battery charger’s instruction manual for information about charging.)

 

NJO

„

NJO „

5-1-1 Mounting the Battery and Setting the Battery Type

Using an Anton/Bauer Battery Pack

1Mount the Anton/Bauer battery pack.

Power supply output connector for lighting

Anton/Bauer

Battery Pack

Lighting control switch

<For your information>

The Anton/Bauer battery holder includes both a power supply output connector for lighting and a lighting control switch, which are convenient when attaching a light. Please contact Anton/Bauer for information about the lighting system.

Release lever

<For your information> Removing the battery pack

Completely push down and hold the release lever on the battery holder. Then, slide the battery pack in the opposite direction to the arrow while holding the lever down.

3Setting the battery type.

Select the battery type listed under BATTERY SELECT. Select BATTERY SELECT from the <BATTERY/ P2CARD> screen in the MAIN OPERATION page.

Please refer to [8-6-2 BATTERY SETTING1] for more information.

The following Anton/Bauer batteries can be used:

•PRO14

•TRIM14

•HYTRON50

•HYTRON100

•HYTRON120

•DIONIC90

•DIONIC160

<Note>

To use DIONIC, please set it as DIONIC90.

64