Chapter 4 Adjustments and Settings for Recording (continued)

4-2 Setting the Electronic Shutter

This section provides a description of the electronic shutter, together with setting and handling directions.

4-2-1 Shutter Modes

The table below shows the shutter modes and speeds for the electronic shutter provided in your AJ-SPC700P.

Mode

Shutter speed

Application

 

 

 

Normal

POSITIONS 1-6

Used to capture clear images

 

 

of a fast-moving subject

 

 

 

SYNCHRO

Range of 60.3

Used to reduce the effect of

SCAN

Hz to 249.7 Hz

horizontal lines when

 

 

shooting a monitor screen

 

 

that has a vertical scanning

 

 

frequency of more than 60

 

 

Hz

 

 

 

SUPER V

 

Used to enhance vertical

 

 

resolution

 

 

 

<Notes>

zIn any mode, the higher the shutter speed the lower the sensitivity of the camera.

zWhen the iris is automatically adjusted, the higher the shutter speed the larger the iris, and the shorter the depth of focus.

4-2-2 Setting the Shutter Mode and Speed

The shutter speed in any shutter mode is set using the SHUTTER switch.

In SYNCHRO SCAN mode, shutter speed can be switched easily, using the synchro-scan adjustment switches (+/–) on the side panel.

Note that the range of selectable shutter speeds may be pre- defined; whether or not to use the SYNCHRO SCAN and SUPER V modes may be determined through the <SHUTTER SPEED> and <SHUTTER SELECT> screens. These screens are accessible through the menu on the CAM OPERATION page.

The selected shutter speed is retained even if the AJ- SPC700P is turned off.

4

1Press the SHUTTER switch, positioned at [ON], towards [SEL].

SHUTTER switch

2Once more, press the SHUTTER switch towards [SEL]. Repeat this switchover until the desired mode or speed appears in the viewfinder screen.

If all modes and speeds are available, the display changes in the following order:

NORMAL mode

1/100 1/120 1/250 1/500 1/1000 1/2000

SUPER V

 

SYNCHRO

mode

 

SCAN mode

<Note>

Your AJ-SPC700P is not factory-set to display the SUPER V mode on the viewfinder screen. To display this mode, set the menu option SUPER V found in the <SHUTTER SPEED> screen, which is accessible from the CAM OPERATION page, to “ON”.

Viewfinder displays relating to the shutter

See [4-7 Viewfinder Screen Status Displays].

33