Chapter 5 Preparation (continued)

5-4-3 When Using Audio Devices

1Connect the audio device to the AUDIO IN jack with the XLR cable.

2Set the AUDIO IN switch to [REAR] for the channel to which the XLR cable is connected.

3Set the LINE/MIC/+48V selector switch on the rear panel to [LINE].

5-5 Connection between the USB

2.0port of the AJ-SPC700P and a PC

By connecting the AJ-SPC700P with an external PC using USB 2.0, the P2 card connected to the AJ-SPC700P can be used as a mass storage device.

Procedures for establishing a connection with a PC

1Connect the USB cable to the USB 2.0 port.

<Notes>

5

z The USB 2.0 cable is not included with AJ-SPC700P. Please use a commercially available USB 2.0 cable (shield with a ferrite core).

z The length of the USB cable shall be not exceed 3 meters. Using a USB cable whose length is greater than 3 meters might result in erroneous operations.

LINE/MIC/+48V

Selector Switch

AUDIO IN Jack

USB

AUDIO IN

2.0 port

Switch

 

2Open the <SYSTEM MODE> screen on the SYSTEM SETTING page from the menu, and set USB to ON.

<Note>

The function of the menu option USB may be assigned to a desired user button by using any one of the menu options USER MAIN SW, USER1 SW or USER2 SW.

These options can be found in the USER SW screen, which is accessible from the CAM OPERATION page.

When you establish the USB connection for the first time, install the accessory P2 software for AJ-SPC700P on the PC. Refer to the Installation Manual for the details.

73