Panasonic DMC-L10K Taking Pictures using Burst Mode, Set the drive mode lever to

Advanced

Taking Pictures using Burst Mode

1 Set the drive mode lever to [].

A

AWhen burst mode is set to high speed [H].

2 Focus on the subject and take a picture.

•Hold down the shutter button fully to activate the burst mode.

∫Changing the burst speed

1 Press [MENU/SET] to display the menu.

2Press 3/4/2/1 to select [BURST RATE] in the [REC] menu [] and then press 1.

3Press 3/4 to select [H] (High speed) or [L] (Low speed) and then press [MENU/SET].

MENU /SET

•You can also use the front dial or the rear dial to select a menu item.

4 Press [MENU/SET] to close the menu.

•You can also press the shutter button halfway to close the menu.

∫Burst speed

		(High)		(Low)
Burst speed
(pictures/	3		2
second)

•The burst speed is constant regardless of the transfer speed of the card.

•The burst speeds indicated are when the shutter speed is faster than 1/60 and the flash is not activated.

•The burst mode speed may become slower depending on the following settings.

–ISO sensitivity (P78)

–Picture size (P94)

–Quality (P94)

–Focus priority (P106)

–Focus mode

•Since the shutter speed becomes slower in dark places, the burst speed (pictures/ second) may become slower.

∫Number of pictures recorded in burst mode

	With RAW files	Without RAW
		files
Number of		Depends on
		the remaining
recordable pic-	max. 3
		capacity of the
tures (pictures)
		card

•Refer to P94 for information about RAW files.

•When there are no RAW files, pictures can be taken until the capacity of the card becomes full. However the burst speed will become slower halfway. The exact timing of this depends on the picture size, the setting for [QUALITY] and the type of card used.

71

VQT1G28