*1 • The VMD information can be searched by Panasonic network disk recorders
*2 • While a camera is during operation such as panning, tilting, zooming, focus adjustment, brightness adjust- ment or auto mode, the VMD information will be added.
The following is the procedure to set VMD areas
Important:
•When the settings are being configured on the setup menu, sometimes the VMD function may not work correct- ly.
Step1
Set the video motion detection area by dragging the mouse on the screen.
→The designated area will become the VMD area and the outline will be displayed. When 2 - 4 VMD areas are set, each area will be numbered in order. The areas will be identified by the respective outline col- ors. The "Status" of the outline to be set for the area will become "Valid".
Step 2
Adjust "Detection area" and "Detection sensitivity" using the slide bar. The currently displayed area and its detection sensitivity will be displayed in the "Detection area" section. Change areas and the settings of "Detection area" and "Detection sensitivity" as neces- sary.
Step 3
Click the [Set] button after completing the settings.
Important:
•The setting will not be applied unless the [Set] but- ton is clicked.
Step 4
To invalidate the VMD area, click the [Set] button after selecting "Off" for "Status" of the VMD area to be invali- dated.
→The outline of the invalidated VMD area will turn to a dotted line. When the VMD area is invalidated, no alarm will occur even when a motion can be recog- nized in the area.
Step 5
To delete the VMD area, click the [Delete] button corre- sponding to the area to be deleted.
→The outline of the respective VMD area will disap- pear.
Step 6
Click the [Set] button.
→The edited settings will be applied.
47
